Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car


Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
- Coupling and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Check of a state and replacement of the directing bearing
   Removal, check of a state and installation of the release bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


5642a57a заправка и чистка автомобильных кондиционеров.


Removal and installation of the executive cylinder of coupling

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!


2. The car also establish to Poddomkratta it on props.

3. A special cap key weaken a nipple nut and disconnect from the executive cylinder the hydraulic line (see an accompanying illustration). Prepare for collecting the spilled liquid. At once to a zakuporta the open ends of the line and nipple connection in order to avoid hit in system of dirt.

4. Turn out two fixing bolts (see an accompanying illustration).

5. Remove the executive cylinder.

Installation

 PERFORMANCE ORDER

1. Install the executive cylinder on the regular place on a coupling dome, by hand tighten fixing bolts. Track correctness of landing of a pusher in a coupling switching off fork pocket.
2. Connect the hydraulic line to the cylinder, then finally tighten fixing bolts. A special cap key strongly tighten a nipple nut.
3. Fill in necessary amount of the DOT 3 brake fluid in the cylinder.
4. Pump over hydraulic system (see Removal of air from a hydraulic path of the drive of switching off of coupling).
5. Lower the car on the earth and connect a negative wire to the battery.