Honda Civic/Acura Integra
since 1994 release
Repair and operation of the car
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Cooling system and heating
- Power supply system and release
Dropping pressure in a power supply system
Check of serviceability of functioning of the fuel pump/pressure of fuel
Check of a state and replacement of fuel lines and their nipple connections
Removal and installation of the fuel pump
Check of a state and replacement of the sensor of fuel consumption
Removal and installation of the fuel tank
Cleaning and repair of the fuel tank - general information
Removal and installation of assembly of the air cleaner
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of injection
Removal and installation of the case of a throttle
Removal and installation of the regulator of pressure of fuel
Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
Power supply system and release
General informationThe power supply system consists of the fuel tank, the electric fuel pump (placed in a gasoline tank), the relay of the fuel pump, the fuel highway with injectors of injection, the regulator of pressure of fuel, assembly of the air cleaner and case of a throttle. All models described in the present manual are equipped with system of the consecutive (distributed) injection of fuel (SEFI).
System of consecutive injection (SEFI)
In the SEFI system electric impulses of accurately limited duration for management of injection of fuel through injectors directly to the inlet port of each of engine combustion chambers are used. The moment and duration of time of opening of each of injectors controls the module of management of the power (RSM). RSM continuously traces various working parameters of the engine and on the basis of the arriving information determines the required volume of the fuel injected into each of inlet ports. The throttle case in this case serves only for management of giving in system of air. In view of the fact that each cylinder is equipped with own injector, this system provides a possibility of very exact management of composition of air-fuel mix.
Fuel pump and fuel pipes
Supply of fuel from a gasoline tank in system of injection and return of its surplus back in a gasoline tank is carried out on two metal lines laid under the car bottom. The electric fuel pump is located in a gasoline tank and is united in uniform assembly with fuel consumption sensor block. The system of return of fuel evaporations carries out removal of vapors of fuel back in a gasoline tank on the separate returnable line.
The main PGM-FI relay (the relay of the fuel pump) is equipped primary and secondary with electric contours. At the included ignition primary contour provides giving of food on RSM, injectors of injection and in a secondary contour of the relay which, in turn, feeds the fuel pump. Giving of food on the fuel pump lasts two seconds when turning the ignition key in position of ON and is continuous at the working engine.
System of production of the fulfilled gases
Oxygen sensors (l-probes), the 3-functional (reducing) catalytic converter, the muffler and exhaust pipe are a part of system of release a final collector, verkhnepotochny (to the catalytic converter) and nizhnepotochny (after the catalytic converter).
The catalytic converter is one of the main components of system of decrease in toxicity of the fulfilled gases is considered in the Head of the Control system of the engine in more detail.
Arrangement of components of a power supply system in a motive compartment (the Integra model with a cross and line design of the case of a throttle)