Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car


Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
- Coupling and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Check of a state and replacement of the directing bearing
   Removal, check of a state and installation of the release bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


5642a57a


Adjustment of a pedal of coupling

Details of adjustment of a pedal of coupling

1 — the Lock-nut of the sensor switch A
2 — the Sensor switch A
3 — the Lock-nut of the sensor switch B
4 — the Sensor switch In disconnections of a chain of a starter
5 — the Auxiliary spring
6 — the Main cylinder of coupling

7 — the Lock-nut of a pusher of the main cylinder
8 — the Full speed of a pedal of coupling
9 — the Free wheeling of a pedal of coupling
10 — coupling pedal Height
11 — Height of the squeezed-out coupling pedal

Pedal height

Height of provision of a pedal is called the distance from its slip to the floor panel (see an accompanying illustration). If the result of measurement of this distance exceeds the limit of admissible range, it is necessary to make the corresponding adjustment.

 PERFORMANCE ORDER

1. For adjustment of provision of a pedal weaken a lock-nut of the sensor switch of coupling (A) or an adjusting bolt and turn out the switch so that it ceased to adjoin to a pedal. Now weaken a pusher lock-nut (see an illustration above) and, rotating the last, correct in a required way height of provision of a pedal. Tighten a lock-nut.
2. Rotating a sensor switch/bolt clockwise, bring it into contact with the pedal lever, then tighten on 3/4 turn/turn. Tighten a lock-nut.
3. Adjust the sensor switch of disconnection of a chain of a starter (see Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter).

Free wheeling of a pedal

Free wheeling is called the distance to which the pedal moves, without encountering resistance and without causing coupling operation (see an illustration above). At an exit of size of a free wheeling of a pedal out of limits of admissible range it is necessary to make the corresponding adjustment.

 PERFORMANCE ORDER

1. For adjustment of a free wheeling weaken a lock-nut on a pedal pusher, then, rotating a pusher, achieve the required result. Tighten a lock-nut.
2. Make sure of correctness of adjustment of the sensor switch of disconnection of a chain of a starter (see Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter)