Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
- Engine
+ Repair of the engine without extraction from the car - the Civic model
- Repair of the engine without extraction from the car - the Integra model
General information
Preparatory actions and the list of repair procedures which can be executed without extraction of the engine from the car
Reduction of the piston of the first cylinder in the provision of the top dead point (TDP)
Removal and installation of a cover of a head of cylinders
Removal and installation of the inlet pipeline
Removal and installation of a final collector
Removal, check of a state and installation of a gas-distributing belt and cogwheels of the GRM drive
Replacement of a forward epiploon of a bent shaft
The VTEC systems - the general information and check of a condition of components
Removal, check of a state and installation of camshafts and assembly of yokes
Replacement of valvate springs with plates and maslootrazhatelny caps
Removal and installation of a head of cylinders
Removal and installation of the pallet of a case of the engine
Removal, check of a state and installation of the oil pump
Replacement of a flywheel / driving disk
Replacement of a back epiploon of a bent shaft
Check of a state and replacement of support of a suspension bracket of the power unit
+ General and capital repairs of the engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
Replacement of valvate springs with plates and maslootrazhatelny caps
Replacement of the broken valvate springs and defective maslootrazhatelny caps of cores of valves on the VTEC models demands preliminary dismantle of a head of cylinders. Remove camshafts and a head of cylinders, then address Part materials the General and capital repairs of the engine of the present Chapter and, working according to the instructions provided in appropriate section, remove valves, valvate springs and maslootrazhatelny caps.On the models which are not equipped with the VTEC system, replacement of the considered components is made without dismantle of a head. The description of the procedure is provided to the VTEC Systems - the general information and check of a condition of components of the Part Repair of the engine without extraction from the car - the Civic model of the present Chapter.