Honda Tsivik + Cars of the Honda Civic and Acura Integra brand + Maintenance instruction + Routine maintenance + Engine + Cooling system and heating + Power supply system and release + Engine electric equipment - Control systems of the engine Specifications System of onboard diagnostics (OBD) - the principle of functioning and codes of malfunctions Removal and PCM/ECM installation Check of serviceability of a state and replacement of the sensor of provision of a butterfly valve (TPS) Check of serviceability of a state and replacement of the sensor of absolute pressure in the pipeline (MAR) Check of serviceability of a state and replacement of the sensor of temperature of the soaked-up air (IAT) Check of serviceability of a state and replacement of the sensor of temperature of cooling liquid of the engine (EST) Check of serviceability of a state and replacement of the sensor of VMT/provision of a cranked shaft / situation of pistons in cylinders of the engine (TDC/CKP/CYP) Check of serviceability of a state and replacement of the sensor of fluctuations of a bent shaft (CKF) Check of serviceability of a state and replacement of the detector of control of electric loadings (ELD) Check of serviceability of a state and replacement of the sensor switch of pressure in system of hydrostrengthening of a wheel (PSP) Check of serviceability of a state and replacement of the oxygen sensor (l-probe) Check of serviceability of a state and replacement of the sensor of a detonation Check of serviceability of a state and replacement of the sensor of speed of the movement of the car (VSS) System of stabilization of turns of idling - the general information, check of a state and replacement of the IAC valve Check of serviceability of a state and replacement of the thermosensitive valve of turns of bystry idling (FIT) System of a perepuskaniye of the soaked-up air - the general information, check of a state and replacement of a diaphragm of the IAB valve System of the operated ventilation of a case (PCV) System of recirculation of the fulfilled gases (EGR) - the general information, check of a state and replacement of components System of catching of fuel evaporations (EVAP) - the general information, check of a state and replacement of components The catalytic converter - the general information, check of a state and replacement + Gear shifting box + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Check of serviceability of a state and replacement of the sensor of fluctuations of a bent shaft (CKF) The CKF sensor consists of the rotor of pulsations located on the forward pin of a bent shaft and induction touch assembly fixed on the engine near a rotor. ECM/PCM uses information arriving from the CKF sensor for determination of size of change of frequency of rotation (fluctuations of turns) of a bent shaft. If fluctuations exceed the limit of admissible range, the module of management regards it as a signal of emergence of admissions of ignition.
Check
|
|
1. Find the CKF sensor electrical wiring socket on the engine block from a gas-distributing belt (see an accompanying illustration). Track that the ignition key was turned in position of OFF and disunite the socket. |
2. Connect an ohmmeter between two external plugs of the socket (not to the central plug). The result of measurement has to lie in the range of 1.6÷3.2 kOhm, otherwise replace the sensor. 3. Serially connect an ohmmeter between the mass of a body and each of external plugs of the socket. If conductivity takes place, replace the sensor. |
|
Replacement
|
|