Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling system and heating
Specifications
Antifreeze - general information
Check of serviceability of functioning and replacement of the thermostat
Check of a condition of the fan(s) of the cooling system and chain of its inclusion, replacement of the fan(s)
Removal and installation of a radiator and broad tank of the cooling system
Removal and installation of the oil cooler
Check of a condition of the water pump
Replacement of the water pump
Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components
Removal and installation of an electric motor of the drive of the fan of a heater
Removal and installation of assembly of the control panel of functioning of a heater and conditioner of air, adjustment of a driving cable
Replacement of the heat exchanger of a heater
Check of serviceability of functioning and service of systems of heating and air conditioning
Check of an electric chain of a clutch coupling of the K/V compressor
Removal and installation of a receiver dehumidifier To/in
Removal and installation of the K/V compressor
Removal and installation of the K/V condenser
Removal and installation of the K/V evaporator with the broad valve
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
Check of a condition of the water pump
Failure of the water pump is capable to cause the most serious consequences, up to full jamming of the engine as a result of an overheat.There are two ways of check of serviceability of functioning of the water pump without its removal from the engine. The defective pump without fail is subject to replacement on new, or restored.
The water pump is equipped control (or ventilating) with openings (see an illustration below).
|
|
. |
In case of failure of an epiploon from openings cooling liquid begins to exude. Prepare a pocket small lamp and a small pocket mirror, then uncover a GRM drive belt. By means of a lamp and a mirror find control openings from below on a back part of the pump and check whether liquid exudes through them.
At failure of bearings of a shaft of the pump in operating time of the engine in its forward part there can be a howling sound which should not be confused to the whistle published by a driving belt when easing effort of its tension. Wear of the bearing can be revealed on existence of a side play when rocking a pulley of the pump (do not forget to switch off before the engine).