Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
- Gear shifting box
- 5-staged manual box of gear shifting
General information
Replacement of epiploons of power shafts
Check of a state and replacement of a support of the transmission
Removal and installation of draft of the drive of gear shifting
Check and replacement of the sensor switch of fires of a backing
Removal and RKPP installation
Capital repairs of RKPP - the general information
+ 4-staged and stepless automatic transmissions (ат and cvt)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of epiploons of power shafts
Leak of gearbox oil is most often connected with wear or mechanical damage of epiploons of power shafts. Replacement of epiploons is made rather simply and does not demand removal of transmission from the car.
|
|
1. Epiploons are located on both sides of a transmission case in places of introduction to them of power shafts. The car also establish to Poddomkratta it on props. A sign of leak of oil through an epiploon are begin to flow oils on RKPP case walls directly under power shafts.
2. Remove a power shaft(s) (see the Head Stsepleniye and power shafts).
|
|
3. By means of mount or the big screw-driver with a flat sting take an old epiploon from the landing nest in a transmission case (see an accompanying illustration). |
4. If to take an epiploon mount or the screw-driver it is not possible, it is necessary to use a special stripper (ask in shops of automobile accessories).
|
|
5. Having used a face head of the corresponding size or a piece of a pipe of suitable diameter as a mandrel, put a new epiploon on the regular place (see an accompanying illustration). Track that the epiploon was put in a nest strictly perpendicularly and on full depth. Oil epiploon sponges gearbox. |
|
|
The mandrel has to rest only against the firm outer edge of a face surface of an epiploon. |
6. Establish into place a power shaft(s) – try not to damage sponges of a new epiploon(s). |
|
|
|
