Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
- Gear shifting box
   - 5-staged manual box of gear shifting
      General information
      Replacement of epiploons of power shafts
      Check of a state and replacement of a support of the transmission
      Removal and installation of draft of the drive of gear shifting
      Check and replacement of the sensor switch of fires of a backing
      Removal and RKPP installation
      Capital repairs of RKPP - the general information
   + 4-staged and stepless automatic transmissions (ат and cvt)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


5642a57a



Check and replacement of the sensor switch of fires of a backing

Check

 PERFORMANCE ORDER

1. First of all check a condition of a safety lock No. 19 on 7.5 A in the assembly block located under the dashboard.
2. Choose as the switching lever the reverse gear and include ignition – white signal lights of a backing have to light up. Switch off ignition.
3. If fires do not join, check serviceability of the corresponding lamps in assemblies of the back combined lamps.

4. If a safety lock and lamps as it should be, find the sensor switch of fires of a backing in the top part of a case of RKPP (see an accompanying illustration), walk on an electrical wiring to the socket back, disunite the last and connect an ohmmeter between two bared contacts.

5. At the switched-on reverse gear between contacts of the socket conductivity has to take place (the sensor switch is closed). In any other position of the lever the sensor switch has to be opened (there is no conductivity).
6. At negative results of the carried-out inspection replace the sensor switch.
7. If the switch as it should be, check serviceability of giving of food for it. In the absence of tension check for break an electrical wiring on the site of a chain between the sensor switch and the assembly block of safety locks. If food moves, check the site of a chain between the sensor switch and the back combined lamps.

Replacement

 PERFORMANCE ORDER

1. Disconnect an electrical wiring from the sensor switch.
2. Turn out the sensor switch from a transmission case.
3. Remove and will throw out an old washer.
4. Replace a washer and install the new sensor switch.
5. Connect an electrical wiring.