Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car

Removal and installation of tips of steering drafts

Removal

PERFORMANCE ORDER

1. Weaken nuts of fastening of the corresponding wheel. A car front also establish to Poddomkratta it on props. Remove a wheel. 2a. Holding a draft tip from a provorachivaniye the second key, release a lock-nut. 2b. Turn off a nut so that there was an opportunity to put a tag of provision of a tip on open rounds of a carving of a bar (see accompanying illustrations). 3. Take the forelock and weaken a nut of a spherical finger of a tip. It is not necessary to remove a nut still finally. 4. By means of a stripper release a sharovy finger of a tip from the lever of assembly of a rotary fist (see an accompanying illustration). Remove a nut and separate draft from a fist. 5. Turn off and remove a tip from draft.

Installation

PERFORMANCE ORDER

1. Screw on draft a new tip (to the landing tag put in the course of dismantle on bar carving rounds). Put a sharovy finger of a tip in the lever of a rotary fist. Do not tighten a tip lock-nut so far. 2. Screw a koronchaty nut of a spherical finger and tighten it with the required effort. Record a nut the new forelock. 3. Strongly tighten a tip lock-nut. 4. Establish a wheel, lower the car on the earth and tighten wheel nuts with the required effort (see Specifications to the Head Routine maintenance). 5. Drive away the car in a specialized workshop for check of angles of installation of forward wheels.