Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
- Power supply system and release
Specifications
Dropping pressure in a power supply system
Check of serviceability of functioning of the fuel pump/pressure of fuel
Check of a state and replacement of fuel lines and their nipple connections
Removal and installation of the fuel pump
Check of a state and replacement of the sensor of fuel consumption
Removal and installation of the fuel tank
Cleaning and repair of the fuel tank - general information
Removal and installation of assembly of the air cleaner
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of injection
Removal and installation of the case of a throttle
Removal and installation of the regulator of pressure of fuel
Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the fuel pump
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action! |
2. Dump pressure in a power supply system (see Dropping pressure in a power supply system).
3. On all models, except Integra the Hatchback of 1998 of the issue, remove a back seat (see the Head Kuzov). On the Hatchback of 1998 of the Issue. Integra models remove a spare wheel and a protective cover.
|
|
4a. Turn out bolts of fastening of a cover of access to the fuel tank to assembly of a gasoline pump (see silt.: Civic models). |
|
|
4b. Fastening bolts – the Integra models. |
|
|
5. Disconnect an electrical wiring from assembly. By means of two wrenches disconnect fuel lines (see an accompanying illustration). |
|
|
6. Give nuts of fastening of the pump (see an accompanying illustration). |
|
|
7. Carefully take assembly from the fuel tank (see an accompanying illustration). |
|
|
8. Remove a protective cover of the main electric socket (see an accompanying illustration). |
|
|
9. Disunite the main electric socket of assembly of the fuel pump (see an accompanying illustration). |
10. Flat-nose pliers squeeze clips of fastening of a fuel hose – remove the top clip, lower shift to the middle of a hose, having completely released the pump union.
11. Disconnect the pump from a basic arm.
|
|
12. Remove from the lower end face of assembly the filtering element (see an accompanying illustration). |
13. Installation is made upside-down. Do not forget to replace sealing laying of a landing flange of a cover of access to the fuel tank. |
|
|
|
