Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
- Power supply system and release
Specifications
Dropping pressure in a power supply system
Check of serviceability of functioning of the fuel pump/pressure of fuel
Check of a state and replacement of fuel lines and their nipple connections
Removal and installation of the fuel pump
Check of a state and replacement of the sensor of fuel consumption
Removal and installation of the fuel tank
Cleaning and repair of the fuel tank - general information
Removal and installation of assembly of the air cleaner
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of injection
Removal and installation of the case of a throttle
Removal and installation of the regulator of pressure of fuel
Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
System of release – the general information
|
|
It is necessary to start service of system of release only after full cooling of its components. Track reliability of fixing of the car in the lifted situation. All cars considered in the present manual are equipped with system of release with the flexible sections extremely sensitive to strong bends. Try not to unbend too pipes at survey of system. |
The system of production of the fulfilled gases of all considered models consists of a final collector(s), a reception pipe, the catalytic converter, the muffler, connecting tubular sections, fixing collars, and also basic arms and rubber loops by means of which final assembly is suspended to the car bottom. The wrong installation of components and sections of system leads to increase in level of the noise and vibrations transferred to a car body.
Regularly examine all system on existence of traces of corrosion, deformations and mechanical damages. Check reliability of tightening of fixture. Violation of tightness of components and their joints is fraught with hit of the fulfilled gases in interior of the car. Defective components and sections are subject to replacement.
At strong damage of system by corrosion for undocking of its sections the gas cutting torch can be required (it is alternatively possible to use a hacksaw or a pneumatic chisel – do not forget to put on goggles and gloves).
Repair of system has to be made in the following order: