Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car


Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
- Power supply system and release
   Specifications
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump/pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor of fuel consumption
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
   System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


5642a57a


Check of a state and replacement of the sensor of fuel consumption

See preventions at the beginning Dropping pressure in a power supply system.


 PERFORMANCE ORDER

1. Remove a back seat (see the Head Kuzov).

2a. At the corresponding complete set remove a protective level of a cover of access to a gasoline tank (see an accompanying illustration).

2b. Uncover access the car floor panel (see an accompanying illustration).

3. Disconnect an electrical wiring from fuel consumption sensor block (see an accompanying illustration).

4. If the sensor fastens by means of a lock ring, use for an otdavaniye of the last a drift (see an accompanying illustration). The ring needs to be developed so that his uvulas were combined with deepenings in the case.


For the purpose of prevention of risk of sparking use only a brass instrument.


5. Take assembly of the sensor from the fuel tank (see an accompanying illustration). Try not to bend the float lever.

6. Connect an ohmmeter to electrical wiring socket plugs (see an accompanying illustration) and measure the electric resistance of the sensor. Measurement should be performed at three provisions of a float corresponding to various extent of filling of a tank (empty, half filled and full). Compare results to requirements of Specifications.

7. At noticeable deviations of results of measurement from norm replace the sensor.

8. Installation is made upside-down do not forget to replace sealing laying of a cover of access to the fuel tank.