Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
- Engine electric equipment
Specifications
Start of the engine from the auxiliary power supply
Check of a state and replacement of the battery
Check of a state and replacement of wires of the battery
System of ignition - the general information
Check of functioning of system of ignition
Check of a state and replacement of the coil of ignition
Check of serviceability of functioning and replacement of the module of management of ignition (ICM)
Removal and installation of the distributor of ignition
Check of installation and adjustment of a corner of an advancing of ignition
System of a charge - the general information and precautionary measures
Check of a condition of system of a charge
Removal and installation of the generator
Replacement of the regulator of tension and brushes of the generator
System of start - the general information and precautionary measures
Check of serviceability of functioning of a starter on the car (in situ)
Removal and installation of a starter
Removal and installation of the traction relay
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
Specifications
System of ignition
Ignition coil
| Characteristic |
Value |
Civic (Hitachi distributor) |
|
Resistance of primary winding, Ohm | 0.45÷0.55 |
Resistance of a secondary winding, kOhm | 22.4÷33.6 |
Civic (TES distributor) |
|
Resistance of primary winding, Ohm | 0.63÷0.77 |
Resistance of a secondary winding, kOhm | 12.8÷19.2 |
Integra |
|
Resistance of primary winding, Ohm | 0.6÷0.8 |
Resistance of a secondary winding, kOhm | 12.8÷19.2 |
Installation of a corner of an advancing of ignition
| Characteristic |
Value |
Civic | |
Models with RKPP D16Y5, D16Y8 | 12 ° ± 2 ° before VMT (Krasn.) at 450 ± 50 rpm |
D16Y7 |
|
USA | 12 ° ± 2 ° before VMT (Krasn.) at 670 ± 50 rpm |
Canada | 12 ° ± 2 ° before VMT (Krasn.) at 750 ± 50 rpm |
Models with AT/CVT |
|
USA | 12 ° ± 2 ° before VMT (Krasn.) at 700 ± 50 rpm |
Canada | 12 ° ± 2 ° before VMT (Krasn.) at 750 ± 50 rpm |
Integra |
|
B18B1, B18C1 | 16 ° ± 2 ° (Krasn.) at 750 ± 50 rpm |
B18C5 | 16 ° ± 2 ° (Krasn.) at 800 ± 50 rpm |
System of a charge
| Characteristic |
Value |
| Minimum admissible length of brushes of the generator, mm |
1.6 |