Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
- Gear shifting box
+ 5-staged manual box of gear shifting
- 4-staged and stepless automatic transmissions (ат and cvt)
General information
Failure diagnostics of AT/CVT - the general information
Check and adjustment of a cable of management of a butterfly valve in the kick-down mode (TV cable) - the Integra models
Replacement and adjustment of a cable of gear shifting
Adjustment and replacement of the sensor switch of position of the lever of the selector of transfers
System of blocking - the general information, check of a state, replacement and adjustment of an electromagnet of management
Check and replacement of electromagnetic valves of management of blocking
Removal and installation of 4-staged and stepless automatic transmissions (AT and CVT)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement and adjustment of a cable of gear shifting
Replacement
|
|
Considered in the present manual of the car are equipped with safety cushions (SRS). When performing any works near sensors of blows, a steering column or the dashboard disconnect SRS (see schemes of electric connections at the end of the Head Onboard electric equipment). |
|
|
1. Remove the central console (see the Head Kuzov).
|
|
2. Transfer the selector lever to situation "N" and remove a fixing clamp from the regulator of a driving cable (see an accompanying illustration). |
|
|
3. The car also establish to Poddomkratta it on props. Otboltite a gear shifting cable arm (see an accompanying illustration). |
|
|
4. Disconnect the holder of a cable from the floor panel, then release a cable from an assembly bracket (see an accompanying illustration). |
|
|
5. Uncover a cable (see an accompanying illustration). |
|
|
6. Give a fixing nut and remove the lever from a rod of management. Try not to bend excessively a cable in the course of its removal and installation. |
7. Installation is made upside-down. Do not forget to make adjustment of a cable (see below). |
|
Adjustment
|
|
1. Remove the central console (see the Head Kuzov).
2. Transfer the selector lever to situation "N", then release a fixing clamp on assembly of the regulator of a cable (see an illustration the first illustration).
|
|
3. Two openings are provided in a tip of a cable. Openings are located at an angle 90 ° that allows to make adjustment of a cable with a step to 1/4 turns. Track that the opening in the regulator was accurately combined with a reciprocal opening in a tip (see an accompanying illustration). |
4. If it is not possible to achieve the required combination of openings, release a lock-nut of a cable and make necessary adjustment. Again strongly tighten a lock-nut.
5. Install a fixing clamp on the regulator. If at installation of a clamp there is its jamming, it is necessary to make sure of correctness of adjustment of a cable.
6. Turn out fixing screws and correct position of the display panel of assembly of switching trying to obtain alignment of its tags.
7. Screw fixing screws and strongly tighten them.
|
|
8. Make sure of combination white risks in the selector lever basis with a tag of "N" on the display panel (see an accompanying illustration). If tags are combined not accurately, correct position of the panel. |
9. Start the engine and check serviceability of switching of the lever of the selector in all possible provisions. If it is not possible to choose any of the modes of the movement it is not possible, address section 2 materials. |
|
|
|
