Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car

Removal and installation of a latch of the lock of a cowl and cable of its drive

Considered in the present manual of the car are equipped with safety cushions (SRS). When performing any works near sensors of blows, a steering column or the dashboard disconnect SRS (see schemes of electric connections at the end of the Head Onboard electric equipment).

Latch

PERFORMANCE ORDER

1. Remove a folding cover of a decorative front grille, then lead round assembly of a latch a marker or a chertilka for the purpose of a guarantee of correctness of its installation at assembly. Turn out fixing bolts from the radiator support panel and remove a latch (see an illustration).

2. Disconnect a lock otpuskaniye cable from assembly of a latch.
3. Installation is made upside-down.

Adjust the provision of a latch so that the cowl was reliably fixed by the lock in a closed position – rubber pillows of support have to be flattened slightly.

Driving cable

PERFORMANCE ORDER

1. Disconnect a driving cable of an otpuskaniye of the lock of a cowl from assembly of a latch (see an accompanying illustration).

2. In interior of the car remove the top overlay of a threshold of a driver's door, then give two fixing bolts and disconnect separate from a partition the cowl lock otpuskaniye lever (see an accompanying illustration). Disconnect a driving cable from the lever.

3. Tie up a piece of a rigid wire by the end of a cable connected to a latch, then "walk" on a cable to a back partition of a motive compartment, on the way releasing it from intermediate clamps.
4. Push the rubber plug through passage through a partition and involve a cable in a motive compartment of the car. Make sure that assembly of a new cable is equipped with the plug through passage. Untie an old cable from a wire and tie up instead of it replaceable.
5. Involve assembly of a new cable for a wire through a partition in a motive compartment.
6. You make further assembly as it should be, the return to a dismantle order.

Fingers densely push the plug of a cable through passage into a partition of a motive compartment – track correctness of landing of the plug in a partition.