Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car

Removal and installation of an internal upholstery of doors

Considered in the present manual of the car are equipped with safety cushions (SRS). When performing any works near sensors of blows, a steering column or the dashboard disconnect SRS (see schemes of electric connections at the end of the Head Onboard electric equipment).

If the stereosystem established on the car is equipped with a security code before disconnecting the rechargeable battery make sure that you have the correct combination for input of the audio system in action!

PERFORMANCE ORDER

1. On models with the manual drive of window regulators remove the glass lowering/lifting handle (see an accompanying illustration).

2. Remove the internal handle of a door (see Removal and installation of latches and cylinders of locks and external and internal handles of doors).

3a. Turn out screws of fastening of the panel of an internal upholstery (see accompanying illustrations).

3b. Removal of an overlay of the handle of an armrest of a door.

3 pages. Reversing of the back screw of fastening of the handle of an armrest.

3d. Reversing of the forward screw of fastening of the handle of an armrest.

3e. Then, accurately hooking the clamps located on perimeter, separate the panel from a doorframe (see an accompanying illustration).

4. Slightly raise the panel and disunite electrical wiring sockets.
5. For the purpose of ensuring access to a door frame accurately hook clamps and remove the plastic insulating screen.
6. Return into place the plastic insulating screen. Before installation of the panel of an internal upholstery do not forget to make sure available on the places of all provided clamps (some from a bottom could drop out in the course of dismantle of the panel).
7. At the corresponding complete set restore initial connection of an electrical wiring of the uniform castle / drive of a window regulator. Press the panel to a door and accurately latch side clamps. Screw fixing screws. At the corresponding complete set establish into place assembly of the switch of the door lock. Install the handle of the manual drive of a window regulator.