Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
- Engine
+ Repair of the engine without extraction from the car - the Civic model
+ Repair of the engine without extraction from the car - the Integra model
- General and capital repairs of the engine
General information
Check of pressure of oil
Check of compression pressure in cylinders
Diagnostics of a condition of the engine with use of the vacuum gage
Removal from the car of the power unit - preparation and precautionary measures
Removal and installation of the engine
Alternative versions of schemes of recovery repair of the engine
Order of dismantling of the engine by preparation it to capital repairs
Dismantling of a head of cylinders
Cleaning and check of a condition of a head of cylinders
Service of valves
Assembly of a head of cylinders
Removal of conrod and piston assemblies
Removal of a bent shaft
Cleaning of the block of the engine
Check of a condition of the block of the engine
Honingovaniye of mirrors of cylinders
Check of a condition of components of conrod and piston group
Check of a condition of a bent shaft
Check of a state and selection of inserts of radical and conrod bearings of a bent shaft
Engine assembly order
Installation of piston rings
Installation of a bent shaft and check of working gaps of radical bearings
Replacement of a back epiploon of a bent shaft
Installation of conrod and piston assemblies and check of size of working gaps in conrod bearings of a bent shaft
Trial start and running in of the engine after capital repairs
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
Engine assembly order
Before starting assembly of the engine, make sure available all necessary details, materials and tools to which number the following belongs: a) Standard set of the metalwork tool;
b) A dynamometer key with the drive on 1/2-dyuymv;
c) The tool for putting on of piston rings;
d) The tool for a staving of piston rings;
e) Short pieces of a fuel hose for putting on on hairpins of covers of conrod bearings;
f) Measuring Plastigage set;
g) Set of probes of lezviyny type;
h) A file with small tooth;
i) Fresh motive oil;
j) Assembly motive or lubricant on the basis of a molybdenum disulphate;
k) Pro-masonry sealant;
l) Sealant for fixing of threaded connections.
For saving of time and minimization of volume of the arising problems you make assembly of the engine in the following order:
|
PERFORMANCE ORDER |
|
|